TopGel

Range of use Closes pores in the wood and small gaps < 0.3 mm before final finishing. Finish shrinkage is therefore prevented and the surface appears visually more full. TopGel does not replace joint putty. Application The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% to 75%, material temperature +18°C to + 25°C, max. wood moisture 12%, sufficiently ventilate working rooms.In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.Thinner / MixingThe product is ready for use and must not be reduced! Application tool / application rateLOBA trowel / approx. 20g/m² (50m²/kg).Drying timeEarliest possible overcoating after 30 minutes.If there are drying delays, wait until completely dry. Application for parquet and wooden flooring:Prepare the substrate properly, prime it and apply LOBA Water-based finish. Drying, intermediate sanding. Carefully apply TopGel with the LOBA trowel. After drying, roller on LOBA Water-based finish.Suitable product combinationsSuitable finishes:can be used in combination with all LOBA finishes in matt, semi-matt and extra-matt finishes. Do not use with gloss systems.