2K Contact

Range of use Suitable for industrially finished ready-to-lay parquet. Allo dust-free re-finishing and the attainment of new surface properties, such as: edge protection, changes in degrees of gloss, dynamic friction for sports flooring as per DIN 18032, slip resistance as per DIN EN 16165:2021-12 or yellowing protection for light woods through the use of UV-Protect.

Application Shake the mixture, add the hardener in a ratio of 2: 1 and mix in by shaking. If partial quantities are to be mixed, these must be weighed out. Can be used for 2 hours after mixing.Shake the contents well.Observe general and, if necessary, product-specific occupational health and safety regulations.

Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.Thinner / MixingThe product is ready for use and must not be reduced!

Application tool / application rateLOBA trowel / approx. 10g/m² (100m²/kg or approx. 75m²/container or LOBA Oil roller Microfiber 60-80 / approx. 30g/m² (ca. 33m²/kg or ca. 25m²/container) Drying timeEarliest possible overcoating after 2 hours.However within 24 hours. Setup recommentdation for UV-finished parquet surfaces: Renovation, Perform basic cleaning with single disc machine, underlayed LOBA special-pad green and LOBA CareRemover 1:4.

Remove disolved dirt with a water vacuum cleaner and neutralise with clear water or use a scourer-vacuum machine.

Allow the surface to dry sufficiently. Newly installed surface, Consult LOBA technical department to check suitability for re-coating. If necessary establish test area and perform adhesion test.

Application of 2K Contact:Apply one coat of 2K Contact. Once dry and tack-free (approx. 2 hours), varnish with 2K Supra A.T. or 2K Duo (non-glossy)