VivaFill

Range of use For closing joints and small areas of damage to bonded parquet and hardwood floors. Old flooring with outsized and dirty joints, as well as wooden constructions involving nailed or screwed hardwood floors, are not generally treated with putty, as the dried putty will break out at least in some parts.

Application The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% to 75%, material temperature +18°C to + 25°C, max.

wood moisture 12%, sufficiently ventilate working rooms.In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.Shake the contents well.Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.Thinner / MixingThe product is ready for use and must not be reduced!

Application tool / application rateLOBA trowel / approx. 50ml/m² (20m²/l). Consumption may vary depending on the joint width.Drying timeFor fine joints, sand after no less than 20 minutes.For renovations with extremely large joints, allow to dry overnight.Rework with the recommended surface treatment systems after no less than 60 minutes.Application:After the medium sand (e.g. 60 grain) and before the fine sand (e.g. 100 grain).

Mix the product with the finest wooden sanding dust as possible for the type of wood in question to form a paste-like, silky putty.

The finer the sawdust used, the easier the putty will be to apply and therefore the better its adhesion to the joint.

The entire floor is scraped off before the fine sanding stage. For larger joints or damage, repeat the process after drying.

Carefully remove the remainder from the surface.

Completely sand away (fine sanding) any putty remaining on the surface after drying. Tip: A perfect color result is achieved at a mixing ratio of 1:10 by weight (sanding dust content to binder).Suitable product combinationsSystems suitable for surface treatment:All LOBA finish and oil systems.