EasyFill

Range of use For closing joints and small areas of damage to bonded parquet and hardwood floors. Old flooring with outsized and dirty joints, as well as wooden constructions involving nailed or screwed hardwood floors, are not generally treated with putty, as the dried putty will break out at least in some parts.

Application The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% to 75%, material temperature +18°C to + 25°C, max.

wood moisture 12%, sufficiently ventilate working rooms.In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.Shake the contents well.Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.Thinner / MixingThe product is ready for use and must not be reduced!

Application tool / application rateLOBA trowel / approx. 100ml/m² (10 m²/l).

Application rate may vary depending on the joints width.Drying timeFor fine joints, sand after no less than 15 minutes.For renovations with extremely large joints, allow to dry overnight.Rework with the recommended surface treatment systems after no less than 60 minutes.Application:After the medium sand (e.g. 60 grain) and before the fine sand (e.g. 100 grain).

Mix the product with the finest wooden sanding dust as possible for the type of wood in question to form a paste-like, silky putty.

The finer the sawdust used, the easier the putty will be to apply and therefore the better its adhesion to the joint.

The entire floor is scraped off before the fine sanding stage. For larger joints or damage, repeat the process after drying.

Carefully remove the remainder from the surface.

Completely sand away (fine sanding) any putty remaining on the surface after drying. Tip: A perfect color result is achieved at a mixing ratio of 1:10 by weight (sanding dust content to binder).Coloring of dark wood species:The coloring of dark woods can be improved by adding Mixol universal tinting paint. Pour 5 litres of LOBA EasyFill into a bucket, add 200 ml of MIXOL and stir with a paint mixer to a uniform consistency.

In order to avoid colour deviations, always mix sufficient mass for a continuous surface.

Mixol Dark Brown 23 For dark wood types like: smoked oak, wenge, pangapanga Mixol Chestnut 20 For reddish wood species such as: jatoba, merbau, mahoganyFurther tips for the described application can be found in the TTT "Filling of dark or reddish woods".Suitable product combinationsSystems suitable for surface treatment:All LOBA finish and oil systems.