DeckDegrayer

Range of use Suitable for use on exterior wooden surfaces. Degray old oiled terrace decks. Clean and prepare old finished terrace deck for re-finishing. Newly laid deck, open pores, wash out wood ingredients from surface.

Application Shake the contents well.Do not work under direct Sun influence. Moisten the surface with water in advance to ensure that the product does not dry too quickly.Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.Thinner / MixingThe product is ready for use and must not be reduced!

Application tool / application rateBrush or LOBA oilbrush / approx. 150-200 ml/m2 (5-6 m2/l). Determine the exact consumption with a test application.Anwendung VorbereitungThree areas of application, one procedure.Degray old oiled terrace decksThe special formulation allows to remove wood graying.

Clean and prepare old finished terrace deck for re-finishingOptimal preparation for secure adhesion of the subsequent finish layer. Newly laid deck, open pores, wash out wood ingredients from surfaceWoods with a high content of wood ingredients, especially coniferous and exotic woods, tend to accumulate on the surface of the wood, e.g. teak that has not been freshly sanded even feels oily.

In order to achieve an optimal bond between our products and the wood, these wood ingredients, resins and oils, must be washed off the surface. This opens the pores of the wood surface as well and the products can be better absorbed. ApplicationRemove loose dirt with broom in advance.

Moisten the surface with water first to prevent LOBA Degrayer from drying too quickly. Apply LOBA DeckDegrayer undiluted with a brush or LOBA oil brush to the wood to be cleaned. Allow material to react for approx.

10 minutes. For process the surface, we recommend a cleaning machine suitable for wooden decks (automatic suction and scrubbing machine, high-pressure cleaner with corresponding attachment, etc.). Alternatively, use a scrubber or brush to work the surface along the wood grain.

Then rinse the entire surface with clear water or spray it with a garden hose. In case of very stubborn soiling, repeat the treatment or allow LOBA DeckDegrayer to work for a longer time. After drying, optionally break up wood fibers with a steel broom or disc machine and LOBASAND SuperPad green to achieve a smoother surface. Re-oil with LOBA DeckOil or coat with LOBA DeckPrepare and LOBA DeckFinish, according to Technical Information on the product.