StyleBase

Range of use Suitable for priming cementitious industrial floor leveling compounds.

Application The cement-based leveling compound must be prepared for direct use according to the manufacturer's instructions.The floor must be dry and free of any previous layers, oil, grease, wax, silicone or any other impurities. Optimum working conditions: room temperature of +15°C - +25°C, floor temperature of +15°C - +22°C, 40% - 75% relative humidity, material temperature of +18°C - +25°C. Working areas must be adequately ventilated.Transfer material to a LOBA varnish bucket before applying.Shake the contents well.Observe general and, if necessary, product-specific occupational health and safety regulations.

Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.This product is part of the LOBA and Wakol "Connected Systems" for finishing cementitious levelling compounds. The approved combinations can be found at: www.loba.de/int_en/loba-wakol-connected-systemsThinner / MixingThe product is ready for use and must not be reduced!

Application tool / application rateLOBA Roller Microfiber 100-120 / 100-120 ml/m² (8-10 m²/l). LOBA Roller Universal 100 / ca. 100-120 ml/m² (8-10 m²/l).Drying timeEarliest possible overcoating after 3 hours up to max.

24 hours.If there are drying delays, wait until completely dry.Intermediate sandingDo not intermediate-sand the primer.Application:Preparation:Apply LOBA StyleFloor or a suitable cement-based levelling compound according to the manufacturer's instructions. Sanding leveling compounds can have a negative effect on the adhesive properties of the surface coating.

Follow the respective technical information provided by the leveling compound manufacturer. Application:1x roll on LOBA StyleBase. Dry for at least 3 hours, maximum 24 hours.Surface treatment2K finish for an extra-matte look, particularly abrasion-resistant and very low-emission 1x LOBA 2K Style 1K finish with 2K Performance, very low-emission and based on renewable raw materials, satin or semi-gloss 2x LOBA EasyFinish Neo 2K finish with extremely high resistance to chemicals and plasticisers, semi-gloss 2x LOBA 2K ResistCare instruction to maintain surface:Detailed recommendations for cleaning and care can be found in the LOBA care instructions.

These general and product-specific recommendations can also be found under www.loba.de.Important informationMechanical resistance:Resistant to mild grinding and rolling load. Liquids:A finished system set-up is a system open to diffusion.

Liquids are to be absorbed immediately, as prolonged exposure can lead to discoloration.

If film injuries (scratches, holes, cuts, etc.) occur, liquids can be absorbed unhindered into the filler.

Depending on the inherent color of the levelling compound or the surface coating, contaminations become more visible, e.g. dark coffee stain on light levelling compound.Only step on unfinished levelling compound with shoe covers. Dirt and moisture acting on the levelling compound, may become visible after surface treatment.