Sportbodenpflege

Range of use Suitable for cleaning and caring for PVC and linoleum coverings in sports halls.

Application Remove any loose dirt and dust in advance using a vacuum, brush or mop.Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.Shake the contents well.Thinner / MixingWater.

Application tool / application rateLOBA mop. On large areas, use a suitable flat wiper mop or a scourer-vacuum machine. / Depending on the application, add approx.

500 - 1000ml to a bucket with 10 l of water, sufficient for 100 m2.Drying timeApprox. 60 min.Application:Initial careIf initial care with a dispersion care product such as LOBA SportCare is not possible, mix Sportbodenpflege in a ratio of 1:10 with water and treat the flooring with it. Wipe any excessively wet areas.

Do not polish. Maintenance care (manual)Mix Sportbodenpflege in a ratio of 1:20 with water and apply with a wiper mop. For spot cleaning, apply Sportbodenpflege undiluted onto the soiled areas and clean intensively with a cleaning machine or moistened hand pad.

Maintenance care (machine)Mix Sportbodenpflege in a ratio of 1:10 with water and clean the flooring with a scourer-vacuum machine. To ensure an adequate care result, do not vacuum off immediately. Allow any residual moisture to dry on the surface.

For spot cleaning, apply Sportbodenpflege undiluted onto the soiled areas and clean intensively with a cleaning machine or moistened hand pad. Stripping:The product can be removed again by stripping it with LOBA Grundreiniger special, although for linoleum flooring LOBA CareRemover must be used. For details, see the product's technical information.Important informationThe surface must not be flooded with cleaning solution.

Using too much water and allowing the product to work for too long can cause swelling and must therefore be avoided. Moisture that has penetrated equipment jackets can cause covering swelling and corrosion, therefore the jacket cover should be left open to dry.