Speed

Range of use Suitable for parquet and wooden floors. For normal to heavy traffic residential areas and light commercial use.

Application The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% to 75%, material temperature +18°C to + 25°C, max.

wood moisture 12%, sufficiently ventilate working rooms.In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.To reduce the risk of excessive swelling, we recommend applying a maximum of 2 roll applications per day.Transfer material to a LOBA varnish bucket before applying.Shake the contents well.Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.This product is part of the LOBA and Wakol “Connected Systems”. The approved combinations with Wakol parquet adhesives may be found in the "Connected Systems" Matrix: www.loba.de/connected-systemsThinner / MixingThe product is ready for use and must not be reduced!

Application tool / application rateLOBA roller Deluxe 120 / 120-150 ml(g)/m² = 6,5-8 m²/l(kg)Drying timeCan be carefully walked on, intermediate sanding can be performed and can be varnished over after no less than 4 hours.Light use after 24 hours.Full use and covering possible after 5 days.The floor can be covered earlier by using LOBA Cover 400, for details see the TI for the product.Drying times are valid for +20°C and 50% relative humidity.Intermediate sandingAble to recoat without intermediate sanding within the first 24 hours. After this time, an intermediate sanding is necessary. An intermediate sanding before the last application will improve the optical appearence of the surface.Use LOBASAND perforated pad P180 or finer, alternatively Sanding Net P180 or finer.Carefully remove dust before overcoating.

Application without primer:Suitable for almost all European and exotic wood types. Please refer to the LOBA wood type list, which can be found at www.loba.de. If in doubt, please contact the factory.

Minimizes the risk of edge bonding. When properly laid and bonded in a shear-resistant or resilient manner, glued parquet and wooden floors, blocking does not occur. For moisture-sensitive woods, parquet on underfloor heating and in renovation cases, we recommend applying only one coat of finish per day.

A total application quantity of 250g/m² is required.

Properly prepare the substrate. Roll finish. Drying. Intermediate sanding. Roll on the last coat of finish. Suitable product combinationsAdditivesThe range of application, properties and appearance can be extended by combining with LOBA additives. Please refer to the respective technical information of the additives for possible combinations, detailed application information, and drying times.